Canzona Technologies Engineering
We treat your business as our own

We have the experience you need

With over 40 years experience, we've probably delivered a working solution for a project similar to yours. A large library of flexible, tested, and reusable software and hardware modules speeds development and reduces expense. Although each design is unique, fundamental principles and common issues reoccur in different forms, and we're quickly up to speed on the latest variation.

Faster, cheaper solutions that work as intended

We listen carefully and study the problems and possible solutions before starting a new design. Like the careful carpenter who "measures twice, cuts once", we think things through before committing to a specific solution, actively seeking those lurking unintended consequences which cause the reckless carpenter to lament "I've cut it three times and it's still too short".

In keeping with our tradition of "simple sophistication" we design with simple functional blocks that can be combined without restriction for sophisticated performance. Fewer "parts" means fewer potential problems, shorter design cycles and lower cost. Even our preliminary designs work quite well, but if there is a problem, we often have a diagnosis by the end of the phone call, and usually provide a solution within 24 hours.

We Meet Deadlines

Rather than proceeding step-by-step along a preconceived path, we look for potential trouble spots and critical features first. By leaving some less essential details for later, we can catch problems and demonstrate important features and functions early in the design cycle.

We look beyond traditional limitations

We push economical technology well beyond its traditional uses without sacrificing speed, reliability or convenience. This can mean additional or enhanced features with little or no additional manufacturing cost, or the basic features at a lower cost.

Billing

New clients sometimes complain of having written check after check to other consultants with little to show for it. To help address these concerns, we can divide projects into small tasks or stages. With each invoice, you will usually receive something tangible such as a schematic, case drawing, software, or circuit board artwork. Frequent reports allow comparing actual progress with the estimated time requirements, and you'll know where the money went when you receive an invoice.

Hourly Rate or Fixed Fee?

Although paying by the hour may seem fraught with uncertainty, it can reduce the total cost and improve the final result. Fixed-fee contracts may read like insurance policies, specifying in detail what is and isn't covered. Any uncovered changes or additions may result in additional charges, and built-in fees for a "worst-case" scenario may result in paying more for a basic design. Rather than single-mindedly focusing on a pre-negotiated, fixed solution, we reevaluate the original design during development, leading to early detection of potential problems and possible enhancements. Adding enhancements early usually won't significantly delay completion, and may even reduce total development time. Adding the same enhancements to a completed project may be rejected because of excessive costs or unacceptable delays and an hourly rate eliminates the need to renegotiate fees and schedules, letting us get on with the work. If you decide things aren't going well, you can cancel the contract at any time, paying only for work already done with no further obligations.
ptr